User's Guide Part 2

259
Data Display/Edit/Management
● Receiving all data at a time
1
Receive Ir data screen (p.258)
“Receive all”
2
Enter your security codeEnter
session number
“Session number”→p.257
3
Direct the Infrared data port toward the
other part’s device“YES”
■ To cancel receiving all Ir data
“NO”
4
Select “YES” when the overwrite
confirmation screen appears
■ To cancel receiving all Ir data
“NO”
5
Receive all data from other party’s device
All the data reception starts.
When the received data is saved, a notification
message appears indicating that the
communication is completed.
■ To exit during the receiving

o (Quit)
Forwarding Data with iC
Communication
<iC Communication>
When transferring data using the iC
Communication
z Place the FeliCa mark “e” on the FOMA terminal
(sender) over the FeliCa mark “e” on the FOMA
terminal (receiver).
z Data transmission may not be smooth depending
on the FOMA terminal of the other party. Move
FOMA terminals so that the FeliCa marks “e” of
the sender and the receiver get close or distant, or
move them to the right, left, up and down.
Transferring one data at a time using
the iC communication
<iC transmission/Touch to receive data>
You can exchange one data at a time with other
devices using the iC communication function.
● Sending one data
Select “iC transmission” from the function menu of
Data list screen or detail screen.
<Example: To send one phonebook data>
1
Phonebook detail screen (p.73)
u (FUNC)“iC transmission”
2
Put the FeliCa mark “ e ” close to the
FeliCa mark “ e ” of the other party
“YES”
The data transmission starts.
When the data is sent, a notification message
about completing the exchange appears.
■ To cancel sending
“NO”
■ To exit during sending
o (Quit)
● Receiving one data
1
Put the FeliCa mark “ e ” close to the
FeliCa mark “ e ” of the other party
Perform the operation to send the data
from the FOMA terminal of the other
party
The data reception starts and the progress bar
appears.
2
“YES”
When the received data is saved, a notification
message about completing the save appears.
The received data is discarded if no operation is
performed for about 30 seconds after it is
received.
■ To exit during the receiving
o (Quit)
■ When you do not save the received data
“NO”