User's Guide Part 1

198
i-αppli
Launching i- α ppli from a site
When an i-αppli software launch specification is
displayed on an i-mode site, this setting allows the
software to be launched from the site.
z This function cannot be used with some sites.
1
Sites screen (p.136)Select an item for
launching the software“YES”
Launching i- α ppli from a mail
When an i-αppli software launch specification is
pasted into a received i-mode mail, this setting allows
the software to be launched from the i-mode mail.
1
Received mail detail screen (pp.170,
172)Select an item for launching the
software“YES”
Launching i- α ppli from other
functions
You can launch an i-αppli from various functions such
as Infrared data exchange function, Bar code reader,
IC card function, ToruCa, data broadcast, etc.
■Infrared data exchange function
When the FOMA terminal received the i-αppli
launching signal while Infrared data exchange, i-αppli
software launches.
■Bar code reader
When the data scanned by the Bar code reader
contains an i-αppli software launch specification, you
can launch the software from the Bar code reader.
■IC card function
You can launch the software by holding the FeliCa
mark on the FOMA terminal over the reader/writer
unit.
■ToruCa
When an i-αppli software launch specification is
pasted into an acquired ToruCa, you can launch the
software from ToruCa.
■Data broadcast
When 1seg data broadcast site contains i-αppli
activation specification, the software can be activated
from the site.
Setting the i- α ppli Standby
Screen
<Set i-αppli stand-by>
You can set a selected i-αppli software as the standby
screen.
z Some software applications cannot be set as the
standby screen.
1
Software list screen (p.187)o (Set)
“Stand-by display”“ON”o (Finish)
Activating the i- α ppli standby screen
You can activate the software set as the i-αppli
standby screen.
1
On the i-αppli standby screent
The i-αppli is activated and or flashes
at the bottom of the screen.
N
z Unlike ordinary i-αppli, some i-αppli software is
immediately launched from an i-mode site.
• These i-αppli are not stored on the FOMA terminal
after downloading from i-mode sites,
•Some i-αppli software cannot be stored on the
FOMA terminal.
N
z The i-αppli launch specification cannot be quoted
even when you reply with a quote or forward the
i-mode mail. You cannot quote a launch specification
of an i-αppli by forwarding mail using the Infrared data
exchange function or DOCOMO keitai datalink
(p.329), etc.
N
<IC card function>
z The software is not launched in the following cases:
• When another function is running
• During calls
• When the software you want to launch cannot be
found
N
z Only 1 i-αppli can be set as the i-αppli standby screen.
z If software that communicates is set as the standby
screen, it may not run correctly when problems such
as poor signal quality occur.
z If you select “OFF” for “Stand-by net” in “Software
setting”, note that you may not be able to receive
timely information.
z If “Dial lock” or “Original lock” is set or 2in1 is set to B
mode or Dual mode while the i-αppli standby screen is
displayed, the i-αppli standby screen ends. If “Dial
lock” or “Original lock” is released or 2in1 is set to A
mode, the i-αppli standby screen reappears.
z When you switch tasks and display the standby
screen, the screen specified in “Stand-by display” of
“Display setting” appears even though the i-αppli
standby screen is set.