User's Guide Part 1

149
i-mode/i-motion/i-Channel
Setting the connection timeout
<Set connection timeout>
This option sets time-out duration for which the
FOMA terminal automatically stops trying to connect
when a site is busy and there is no response.
1
i“SETTINGS”“i-mode common
set”“Set connection timeout”
Select any item:
60 seconds……Automatically stops connecting if
there is no response for 60 seconds.
90 seconds……Automatically stops connecting if
there is no response for 90 seconds.
Unlimited……Does not automatically stop
connecting.
Setting a host different from i-mode
host (ISP connection)
<Host selection>
You need to select a different host when you want to
use a service other than i-mode. If you change the
host to a host other than i-mode, you can not use
i-mode and i-mode mail.
z You can store up to 10 hosts other than “i-mode”.
1
i“SETTINGS”“i-mode common
set”“Host selection”Highlight
“<Not recorded>”o (Edit)Enter
your security codeSelect any item:
Host name……Sets the host name. You can enter
up to 9 double-byte or 18 single-byte characters.
Host number……Sets the host number. You can
enter up to 99 single-byte characters.
Host address……Sets the host address. You can
enter up to 30 single-byte characters.
Host address2……Sets the host address2. You can
enter up to 30 single-byte characters.
2
Set the respective items  o (Finish)

Specifying whether to use terminal
data in Flash movies
<Use phone information>
Use this function to specify whether terminal data is
used when a Flash movie is running.
z The terminal data may be used depending on the
particular Flash movie. Select “Accept” in “Use
phone information” of “i-mode settings” so that
images use the terminal data. The default setting is
“Accept”. Such movies may use the following types
of terminal data:
• Battery level • Ring volume setting
• Signal strength • Select language
• Date and time • Model data
1
i-mode setting screen (p.148)“Use
phone information”“Accept” or
“Reject”
Using SSL Certificates
You can check the details of an SSL certificate or to
set to valid/invalid.
1
i“SETTINGS”“i-mode common
set”“Certificate”
2
Select a certificateCheck the details
■ To validate or invalidate SSL certificates
Highlight a certificate
u (FUNC)“Valid/
Invalid”

* There is normally no need to change this
setting.
N
z Note that costs of packet communication while you are
connected to a host other than i-mode are not covered
by the Pake-Houdai or Pake-Houdai full deal.
z When you change the host, the ticker of i-Channel is
turned off. The ticker is turned on again automatically
when the information is updated automatically or
when p is pressed to receive the latest information.
z After changing the host, the i-Channel information
may not be updated automatically. To receive the
latest information, press p to display the channel list
screen.
N
z When set to “Valid”, “ ” appears. When set to
“Invalid”, “ ” appears.
z If you select “Invalid”, you cannot view SSL pages with
that SSL certificate.
N