User's Guide Part 1

119
Continued on next page
Camera
■Flashing of illumination when shooting
z The center illumination lamp lights up or flashes as
follows:
• Shooting screen activated: Flashes in red
• Shooting still images, M-continuous mode: Lights
in red (about 3 seconds)
• A-continuous mode: Lights in red (when
shooting)
• Shooting movies, recording in Voice mode:
Flashes in red
• Auto timer activated: Flashes in blue→p.128
■Saving the still images, movies, etc. you shot
z The images, movies, etc. are saved in the folder
specified in “Select to save”.
z You can save the still images, movies, etc. you shot
automatically when “Auto save set” is set to “ON”.
z If the battery is low, you may not be able to save the
still images, movies, etc. you shot.
z If the FOMA terminal is turned off or the battery
pack is removed while saving the files, incomplete
files may be saved.
■When the shooting is interrupted
z The shooting is interrupted when you receive a
voice/videophone or 64K data communication, or
alarm notification (1Seg booking program, 1Seg
timer recording, Alarm, Schedule or To Do list), or
operate other functions.
• When shooting images continuously or shooting
movies, the shooting is interrupted and
respective screens appear. When you exit from
these screens, the camera screen reappears so
that you can save the data you shot before
receiving calls or alarm notification.
• When adjusting the zoom or brightness of the
camera, the adjusting setting is set and the
screen returns to the camera menu.
• The Auto timer is canceled.
z The shooting is not interrupted in the following cases:
• When you receive mails or MessageR/F when
using the camera (including the case that the
shooting screen appears), the reception result
screen does not appear and the shooting mode
continues regardless of the “Receiving setting”.
• When “Alarm setting” is set to “Operation preferred”,
you can continue the shooting, make settings or
operate the Auto timer without interruption even
when the alarm specified time is reached.
■ When using the microSD card
z When saving the data on the microSD card, “ ”
flashes. Do not remove the microSD card during
this period. This may cause a malfunction to the
FOMA terminal or microSD card.
z When “microSD” is selected in “Select to save” and
there is no folder in the microSD card, a folder is
created automatically.
z If the number of files in the microSD folder selected
in “Select to save” has reached the maximum, you
cannot set to the folder.
Image size and maximum number of
images/shooting time
The following Table 1 to 3 (pp.119, 120) shows the
image sizes, number of still images and movie
shooting time supported by FOMA SO706i.
[Table 1] The image sizes and shooting mode
[Table 2] The approximate number of still images that can be saved by destination to save
• The number of images that can be saved varies depending on the shooting environment, etc.
Image size
Photo
mode
Continuous
mode
Movie
mode
2M (1,200 × 1,600)
○××
1M (960 × 1,280)
○××
VGA (640 × 480)
○××
CIF (352 × 288)
○○×
Screen (240 × 427)
○○×
QVGA V. (240 × 320)
○○×
QVGA (320 × 240)
××○
QCIF (176 × 144)
○○○
SubQCIF (128 × 96)
○○○
Quality 2M 1M VGA CIF Screen QVGA V. QCIF SubQCIF
Destination: FOMA SO706i (Phone)
Super Fine 116 140 341 700 1,000
Fine 140 700 1,000
Normal 229 1,000
Destination: microSD (64M bytes)
Super Fine 99 118 291 542 948 1,897
Fine 118 542 948 1,897
Normal 189 948 1,265 3,795