User's Guide Part 2

265
1Seg
●
If the alarm time comes in the following cases,
the alarm may operate when the status changes
to during a call or stand-by.
- While placing/receiving a voice/videophone
call or originating/receiving a PushTalk call
- During packet communication
- During the infrared communication/while the
infrared remote control is being used
- During the iC communication
- During data communication or while reading/
writing data from/into a microSD memory card
on a PC with the FOMA terminal connected
using the USB cable
- While recording a still image/movie
- While the Schedule alarm is sounding
- Beep while receiving Area Mail, while
sounding Area Mail ring tone, or displaying
Area Mail
●
If you leave the FOMA terminal with the battery
pack removed or fully expended for a long
period of time, the date and time is reset, and the
Booking alarm may not operate correctly.
At the Timer Recording Starting Time
A recording is automatically started. When the
timer for recording a program starts while One
Seg is not activated, “
” appears. After the
recording is completed, the notification icon
“
” (Timer Rec result) appears in the stand-by
display.
ˎ
Extend the One Seg Antenna fully while recording a
program.
Ｔｉｍｅｒ Ｒｅｃ ｒｅｓｕｌｔ １
To check the reservation result
Press (Link) in the stand-by display and select
“ ”.
Ｐｒｅｐａｒｉｎｇ ｔｏ Ｒｅｃ
○
△
の不思議
○
△
の不思議
毎週木曜よる
１０ 時〜
第
２２５ 回
ペンギンの一生
■豆知識
■クイズ
■撮影裏話
■次回予告
○
×
ｃｈ
When the timer recording starting time comes while
watching One Seg
The Preparing to Rec display appears. To cancel
recording, press and select [Yes].
To cancel the recording during timer recording
Press while recording and select [Yes].
●
Even if the Dur multitask Rec is set to [Prefer
recording], the timer for recording a program
may be canceled in a case such as when there
are too many active functions or there is not
enough memory. Also, while transferring data to
the microSD memory card, the recording does
not start.
●
If the Dur multitask Rec is set to [Prefer
operat.] and when functions that cannot be
run simultaneously are active, the screen for
confirming whether to start the timer recording
appears. When you select [Yes], the timer
recording starts.

However, regardless of selecting [Yes] on the
confirmation screen, the timer for recording a
program may not start in a case such as when
there are too many active functions or there is not
enough memory.
●
Even if the FOMA terminal is outside of the
broadcast service area when the timer recording
starting time comes, the timer recording works
effectively.

However, the timer recording fails if the FOMA
terminal is outside of the broadcast service area
all the time from the beginning to the end of the
scheduled recording time. The message “Could
not receive broadcast wave” appears in the
Result detail display (P.251).
Continued