User's Guide Part 2

324
Data Display/Edit/Management
Using the Infrared Remote
Control
Once infrared remote control software is
downloaded from a site and saved in the
FOMA terminal, the FOMA terminal can be
used as the TV or DVD player remote control.
ˎ
To use the infrared remote control, it is necessary to
download the software corresponding to the target
equipment. Even if the corresponding software is
used, some equipment may not be operated.
ˎ
The infrared remote control key operations vary
depending on the software.
■
Remote control operation
When using this function, point the FOMA terminal’s
infrared data port at the remote control receiver
of the TV or DVD player and operate the FOMA
terminal within about 4 m remote control range. Note
that communication may be affected by the target
equipment or ambient brightness.
Within
about 4 m
Reception angle:
±15 degrees
off axis
Infrared
data port
What is iC Communication
Function?
You can send and receive data by placing
the FOMA terminal provided with the iC
communication function over the FeliCa mark
of another FOMA terminal.
ˎ
Data that can be sent and received by iC
communication is the same as the data exchanged
using infrared communication (P.328).
ˎ
You cannot perform the iC communication
during a call, i-mode/packet/64K data/infrared
communication, or when the Lock all, Omakase
Lock, Personal data lock, Lock key, Self mode, or IC
card lock is set.
ˎ
To receive data using iC communication, make
sure that the FOMA terminal is in stand-by status.
You cannot receive data when operation of another
function is in progress.
ˎ
During the iC communication, the status of the
FOMA terminal is the same as the outside of the
service area status. Therefore, you cannot place a
call or perform i-mode and data communication.
ˎ
Data may not be sent/received depending on the
recipients’ terminals. In this case, move the FOMA
terminals so that both FeliCa marks “
” are closer
or farther together, or move the FOMA terminals ups
and downs or back and forth.
ˎ
When you send mail data, all of the title may not be
received depending on the recipient’s terminal.
Performing iC Communication
ˎ
Place the FeliCa mark “
” of the FOMA terminal
over that of the other terminal. Do not move either
of the FOMA terminals until the data exchange is
completed.
FeliCa mark