User's Guide Part 1

Before Using the Handset
36
Using the UIM
The UIM (FOMA card) records user information such as your phone number. Insert a
UIM in the FOMA terminal to use it.
Inserting/Removing the UIM
When inserting/removing the UIM (FOMA card), make sure to power off and close the
FOMA terminal, remove the battery pack, and perform the operation with the FOMA
terminal held with your hand.

If you insert the UIM forcibly, it may be damaged.
■
Inserting the UIM
1
Pull the tab and then pull
out the tray.
Pull out the tray until it stops.
Tab
2
Place the UIM on the tray
with the IC side facing
up.
Align the notches of the tray
and UIM.
Notch
3
Push the tray until it
stops.
■
Removing the UIM
1
Pull the tab and then pull out the tray.
2
Lift up the UIM with your finger to take it out.
●
When you remove the UIM from the tray, be careful not to damage the terminal of the battery
pack.
●
Make sure to keep a removed UIM safely.
About the UIM Security Code
You can set two Security codes, namely “PIN1” and “PIN2”, for the UIM (FOMA card).
These codes are set to “0000” at the time of subscription. You can change them to
any 4- to 8-digit number you want (P.118).