User's Guide Part 1

169
i-mode/i-motion/i-Channel
Setting i-mode
<i-mode setting>
Setting the Connection Timeout
The duration before disconnecting the FOMA
terminal automatically can be set when you
cannot send or receive data due to heavy
traffic at the i-mode center.
1
From the i-mode menu, select [i-mode
setting]
→
[Common setting]
→
[Connection timeout] and press
.
[60sec]:
Disconnect automatically when unable to send/
receive data for 60 seconds.
[90sec]:
Disconnect automatically when unable to send/
receive data for 90 seconds.
[Unlimited]:
Do not set the connection timeout (however, the
connection can be disconnected due to the radio
wave condition or other reasons).
2
Select the waiting duration and press .
The Connection timeout is set.
Changing the i-mode Host (ISP
Connection Communication)
※
You do not need to change the Host setting
when using the i-mode service of DoCoMo.
You can set up to 10 hosts for receiving
services other than the services provided by
i-mode (DoCoMo). When you change a host
to other than [i-mode(UIM)], you cannot use
i-mode.

You must always enter [Host name], [Host number],
and [Host address].
1
From the i-mode menu, select [i-mode
setting]
→
[Common setting]
→
[Host
selection] and press
.
Ｈｏｓｔ ｓｅｌｅｃｔｉｏｎ
ｉ−ｍｏｄｅ（ＵＩＭ）
To edit the settings of the set host
Move the cursor to the set host and from the
Function menu, select [Edit], and enter the
Security code. Edit each item.
To delete the set host
Move the cursor to the set host and from the
Function menu, select [Delete one], enter the
Security code, and select [Yes].
2
Press (Create).
The Security code screen appears.
3
Enter the Security code and press
(OK).
Ｈｏｓｔ ｓｅｔｔｉｎｇ
Ｈｏｓｔ ｎａｍｅ
Ｈｏｓｔ ｎｕｍｂｅｒ
Ｈｏｓｔ ａｄｄｒｅｓｓ
Ｈｏｓｔ ａｄｄｒｅｓｓ２
[Host name]:
Enter a host name within eight full-width or 16
half-width characters.
[Host number]:
Enter a host number within 99 half-width
alphanumeric characters and symbols.
[Host address]/[Host address2]:
Enter a host address within 30 half-width
alphanumeric characters and symbols.
4
Enter each item.
5
Press (Complete).
The entered host is saved.
6
Select the host and press .
The host is changed.
●
Note that packet communication is not covered
by the Pake-Houdai/Pake-Houdai Full service if a
host of the packet communication is set to other
than [i-mode(UIM)].
Continued