User's Guide Part 2

446
Appendix/External Devices/Troubleshooting
No more file number. Please
reset
ˎ
The file number which is
attached to an image saved
in the microSD memory card
and incremented with the
number of saved images
has reached the maximum
number (999-9999). Perform
the Reset file No. or delete
the images from the largest
file numbers (P.177, 317).
No requested software
ˎ
The i-
α
ppli software to
be started from the site
or mail, or by the infrared
communication is not stored
in the FOMA terminal.
No response
ˎ
Failed to identify a recipient
of iC communication. Check
if both FeliCa marks “
” are
opposed correctly with each
other or the other device
operates properly (P.327).
ˎ
Failed to recognize the
other device for the infrared
communication. Check
if the infrared data ports
are pointed at each other
correctly or if the other
device operates properly
(P.323).
No response (408)
ˎ
The communication is
interrupted because there is
no response from the site or
website. Retry the operation
after a while.
No space in main memory
ˎ
Another image recorded by
the camera cannot be saved
because of no memory
to save it on the FOMA
terminal. Change the image
quality or image size, or
delete unnecessary images
(P.158, 174, 317).
ˎ
The remaining memory
on the FOMA terminal
is insufficient. Delete
unnecessary data (P.103,
189, 190, 219, 254, 317,
362, 369).
No space to attach signature
ˎ
Failed to attach the signature
because the total number of
characters in the mail main
body and signature exceeds
5,000 full-width or 10,000
half-width characters.
Decrease the number of
characters in the mail main
body or send mail with no
signature attached (P.203,
223).
Not enough space in microSD
ˎ
Another image recorded by
the camera cannot be saved
because of no vacant space
to save it in the microSD
memory card. Change the
image quality or image
size, or delete unnecessary
images (P.158, 174, 317).
Not supported by this Reader/
Writer
ˎ
The recipient’s terminal
does not support the iC
communication.
O
Omakase Lock activated
ˎ
The Omakase Lock is set.
While the Omakase Lock
is set, all key operations
are disabled except for
answering an incoming
voice or videophone call and
powering on/off (P.136).
Out of service area
ˎ
The i-mode services are
not available since you are
outside of the service area or
in a location without the radio
wave. Move to a location
where “
” disappears
(P.30).
P
Page is not found (404)
ˎ
The site, website, etc. cannot
be located. Check if the URL
you entered is correct.
Personal data locked
ˎ
The Personal data lock is
set. Cancel the Personal
data lock and then retry the
operation (P.137).
Please wait for a while
ˎ
Voice line/packet
communication system
failure or very high
congestion in voice line/
packet communication
network. Retry after a while.
However, you can still
place a call to 110, 119, or
118, with some exceptions
depending on the situation.
Please wait for a while (packet)
ˎ
Packet communication
system failure or very
high congestion in packet
communication network.
Retry the operation after a
while.
Positioning failed
ˎ
Failed to position the current
location. Move to a location
with better radio wave
condition and then try it
again.
Public mode (Drive mode)
ˎ
The Public mode is set.
Cancel the Public mode
and then retry the operation
(P.69).