User's Guide Part 2

442
Appendix/External Devices/Troubleshooting
Error Messages
ˎ
In some cases, a 3-digit number may be displayed together with a message. This is a DoCoMo
own code that DoCoMo displays on the FOMA terminal.
A
Accessing IC card. Cannot
delete
ˎ
Failed to delete the software
because data in the Osaifu-
Keitai-compatible i-
α
ppli IC
card is being accessed.
Address is not valid (451)
ˎ
Failed to send the mail
because of unknown mail
address. Enter the correct
mail address and send it
again.
Another function is active.
Cannot activate this at the
same time
ˎ
Another function that cannot
be run simultaneously by
multitask-ing is active. Quit
the function, if it is not being
used, and then retry the
operation (P.349).
Authentication failed
ˎ
Failed in verifying the
authentication password.
Set the password so that it
matches the one of the other
device and then retry the
operation (P.325, 326, 328,
329).
ˎ
The authentication type
(one/all) does not match the
one set for the other device.
Set the same authentication
type (one/all) on both party
to exchange data using the
infrared or iC communication
(P.325, 326, 328, 329).
Authentication type is not
supported (401)
ˎ
Failed to connect to the site
or website, etc. because
of the unsupported
authentication type.
C
Camera function error. Quit
the application
ˎ
The Camera mode is
terminated because of
an error occurrence. To
continue to use the camera,
restart the Camera mode.
Camera function error.
Save the data and quit the
application
ˎ
The Camera mode is
terminated after the image
is saved because of an error
occurrence. To continue to
use the camera, restart the
Camera mode.
Camera function error. Switch
to Substitute image
ˎ
The videophone image is
switched to the substitute
image because of an error
occurrence. Switch it again
to the camera image (P.51).
Cannot execute because of
memory shortage
ˎ
Failed to execute the
function because of
insufficient memory.
Cannot move. Not enough
memory
ˎ
The remaining memory
in the microSD memory
card is insufficient. Delete
unnecessary data (P.103,
189, 190, 219, 254, 317,
362, 369).
Cannot read. You need to
format
ˎ
The microSD memory card
is not formatted correctly.
Format it using the FOMA
terminal (P.309).
Cannot support content
ˎ
Data that is not supported
by the FOMA terminal is
contained in the contents.
Cannot switch mode
ˎ
Failed to set to the microSD
or MTP mode because of
a communication using
the FOMA USB Cable
with Charge Function 01
(optional) in progress.
Certificate is rejected
(tampered)
ˎ
There are some problems
with the certificate.
Check address
ˎ
The SMS address exceeds
21 digits or 186/184 is
entered at the beginning
of the address. Enter the
correct address and send it
again (P.230).
Check SMS Center setting
ˎ
The incorrect host is set
at the SMSC. Restore the
host to “DoCoMo”, the
default setting at the time of
purchase (P.232).
Connection failed
ˎ
The host number set for the
Host selection is incorrect.
Restore the host number to
“i
モード
”, the default setting
at the time of purchase
(P.193).
ˎ
Failed to connect because of
weak radio wave condition.
Retry to connect from a
place with better radio wave
condition.