User's Guide Part 2

403
PC Connection
Preparations and Flow of
Data Communication
The preparations required for performing
packet and 64K data communication by
connecting the FOMA terminal to a PC are
given below.
When you use the
FOMA PC setup
software
Install the FOMA communication configuration files (USB drivers).
Connect the FOMA terminal to a PC.
Check the installed FOMA communication configuration files.
Set a host.
Packet
communication
ˎ
“mopera U” or
“mopera”
ˎ
Other provider
Perform communication.
Start up communication software that is
compatible with AT commands.
Set a host.
Set ON/OFF for the Notify caller ID.
Set up the dial-up network.
Perform dial-up connection.
When you do not
use the FOMA PC
setup software
Install the FOMA PC setup software.
64K data
communication
ˎ
“mopera U” or
“mopera”
ˎ
Other provider
AT Commands
AT commands are the commands (instructions)
that are executed on a PC for setting and
changing the functions of the FOMA terminal.
For more information on the AT commands, see
the “Manual for PC connection setting” (PDF
format) included in the supplied CD-ROM.
About the Supplied CD-ROM
The supplied CD-ROM contains the software
required for data communication using
the FOMA terminal and the “Manual for
PC connection setting”/“Kuten Code List”
operation instructions (PDF format). For details,
see the supplied CD-ROM.
<Software/PDF>
◆
FOMA communication configuration files
◆
FOMA PC setup software
◆
FOMA byte counter
◆
General information about DoCoMo keitai datalink
◆
FirstPass PC software
◆
General information about mopera U (mopera U start
up tool/mopera U connection & setting tool/mopera
U requesting original data/FOMA byte counter)
◆
General information about Napster
®
◆
“Manual for PC connection setting” in PDF format
◆
“Kuten Code List” in PDF format
◆
Adobe
®
Reader
®
◆
Picture Motion Browser Ver.2.2.01
◆
Declaration of Conformity (DoC)
Continued