User's Guide Part 1

Voice/Videophone Calls
59
2
Select the Chaku-moji display style and press .
The display style for Chaku-moji is set.
Placing a Call with a Chaku-moji Message
You can place a voice or videophone call together with a Chaku-moji message.
1
Enter a phone number in the stand-by display and press (Option).
The Call menu appears.
2
Select [Chaku-moji] and press .
Ｓｅｌｅｃｔ ｔｈｅ ｗａｙ
ｔｏ ｉｎｐｕｔ
ｃｈａｋｕ−ｍｏｊｉ
Ｎｏｎｅ ｓｐｅｃｉｆｉｅｄ
Ｃｒｅａｔｅ ｍｅｓｓａｇｅ
Ｓｅｌｅｃｔ ｍｅｓｓａｇｅ
[None specified] :
Place a call without a Chaku-moji message.
[Create message] :
Create a Chaku-moji message and place a call.
Enter a message within 10 characters regardless of
pictographs, symbols, full-width, or half-width.
[Select message] :
Select a saved Chaku-moji message and place a
call. (This menu appears only when the Chaku-moji
message is saved.)
[Sent messages] :
Select a sent Chaku-moji message and place a call. Up
to 10 Chaku-moji messages can be saved. (This menu
appears only when there is a sent Chaku-moji message.)
3
Compose/Select a Chaku-moji message.
The Chaku-moji message is composed/selected.
4
Select another call condition and press (Call).
Ｃａｌｌｉｎｇ
Ｕｒｇｅｎｔ
The call is dialed according to the selected Chaku-moji message and call
condition.
●
When a Chaku-moji is received by the recipient, “ ” appears in the sender’s terminal
display and charge is required.
●
If the recipient does not receive the Chaku-moji, “ ” appears. In this case, there is no
charge. (For example, when the recipient’s terminal does not have Chaku-moji support or
if the Chaku-moji was received in a condition other than that set using the Set Message
display menu.)
●
If the recipient’s terminal has the following settings or conditions, Chaku-moji cannot be
delivered to this recipient and the call is not saved in the Received record of the recipient’s
terminal. “
” or “ ” is not displayed on the sender’s terminal and there is no charge for this
transmission.

- When the recipient’s terminal is outside of the service area

- When the recipient’s terminal is powered off

- When the Public mode (Drive mode) is set

- When the To answer the Record message is set to 0 seconds, etc.
●
Even if a Chaku-moji was delivered successfully to the recipient, “ ” or “ ” may not be
displayed in the sender’s terminal display depending on the radio wave condition. In this
case, charge is required.
●
If you place a videophone call with a Chaku-moji while the Auto redial(voice) is set to [ON],
the Chaku-moji is sent even when this call is redialed as a voice call.