User's Guide Part 1

Before Using the Handset
45
Notifying the Recipient of Your Phone Number
<Notify caller ID>
When placing a call, your phone number can be shown in the display of the
recipient’s phone you are calling.
ˎ
The caller ID is important personal information. Carefully decide whether you notify a recipient
of your caller ID.
1
From the Menu, select [Settings]
→
[Management]
→
[NW Services]
→
[Notify
Caller ID]
→
[Set Notification] and press
.
2
Select [Notify]/[Not notify] and press .
The Notify caller ID is set.
To check the setting
From the Menu, select [Settings]
→
[Management]
→
[NW Services]
→
[Notify Caller ID]
→
[Check setting].
●
The setting, whether to originate a PushTalk call with/without the caller ID, follows this setting.
●
If you hear a guidance asking to send the caller ID when you place a call, call again after
setting the Set Notification to [Notify] or by adding “186” before the recipient’s phone
number. The caller ID is not displayed even if you add “186” when you originate a PushTalk
call.
●
You cannot set the Notify Caller ID when the FOMA terminal is outside of the service area.
Checking Your Own Phone Number
<Own number>
Your phone number can be checked. You can also save your name, mail address,
etc.
ˎ
If the Own number is saved as Secret, the data other than your phone number is not displayed.
Set the Secret display to [ON] to display all data.
ˎ
Number B does not appear on the Own number display of the B mode at the time of purchase.
To display Number B, perform the Check service (P.47).
1
From the Menu, select [Own number] and press .
０９０ＸＸＸＸＸＸＸＸ
ｄｏｃｏｍｏ．ｔａｒｏ．
△△
＠ｄｏｃｏｍ
ｏ．ｎｅ．ｊｐ
ドコモ太郎
ト゛コモタロウ
ＯＦＦ
Ｂａｓｉｃ Ｄｅｔａｉｌ
Your phone number appears at [ ]. If the data other than a phone
number is saved, that data also appears.
To place a call
Press , move the cursor to a phone number, and press .
To originate a PushTalk call
Press , move the cursor to a phone number, and press .
To send i-mode mail
Press , move the cursor to a mail address, and press (Mail).
To check the image
Press , move the cursor to the image, and press (Play).
To switch the Own number display between the A and B modes when 2in1
is set to the Dual mode
Press (Number A)/ (Number B).
Continued