User's Manual Part 2

395
Appendix/External Devices/Troubleshooting
以下の宛先にはメール送信できま
せんでした（
561
）
Mails could not
be sent to following address
○ ○
@
△ △ △
.ne.jp
※
Mail addresses vary depending
on each recipient.
ˎ
Failed to send mails to some mail
addresses. Move to a location
with better radio wave condition
and then send them again.
Main memory shortage
ˎ
The remaining memory on the
FOMA terminal is insufficient.
Change the image quality or im-
age size, or delete unnecessary
images (P.147, 154, 290).
Main memory shortage. May not
save
ˎ
An image you edit may not be
saved because of insufficient
memory on the FOMA terminal.
Delete unnecessary images
or move some images to the
microSD memory card (P.283,
290).
MainMenu cannot be activated now
ˎ
Failed to display the menu be-
cause a function that does not
support menu display is execut-
ed.
Manner mode is set
ˎ
Failed to adjust the volume be-
cause the Manner mode is set.
Cancel the Manner mode and
then retry the operation (P.108).
Memory shortage
ˎ
The operation is interrupted
because of insufficient memory.
If the message is frequently
displayed, power off the FOMA
terminal once and then power it
on again.
Memory shortage. Cancel operation
ˎ
The operation is discontinued be-
cause of insufficient memory.
Message rejected and cannot be
received
ˎ
Failed to send SMS because the
recipient rejects receiving SMS.
Message rejected and cannot be
sent
ˎ
Failed to send SMS because
sending SMS is rejected.
microSD error
ˎ
Failed to access the microSD
memory card (loading error, etc.).
Remove the microSD memory
card once and insert it again
(P.279). If this message appears
again, the microSD memory card
may be damaged.
N
No assigned channel to this keypad
ˎ
No channel is assigned to this
key. Either press other key or edit
a remote-control number (P.243).
No content is available (204)
ˎ
The site or website you specified
contains no display data.
No memory space
ˎ
The number of entries saved
in the Phonebook has reached
1,000. Delete unnecessary entries
in the Phonebook (P.98).
ˎ
The number of saved schedules
has reached 300. Delete unnec-
essary schedules (P.326).
ˎ
Failed to save the data. This
message appears if there is not
enough memory when you at-
tempt to exchange data using the
infrared or iC communication.
ˎ
There is not enough memory to
save new data. Delete unneces-
sary data (P.294).
No more file number. Please reset
ˎ
The file number which is attached
to an image saved in the microSD
memory card and incremented
with the number of saved images
has reached the maximum num-
ber (999-9999). Perform the Reset
file No. or delete the images from
the largest file numbers (P.156,
290).
No requested software
ˎ
The i-
α
ppli software to be started
from the site or mail, or by the
infrared communication is not
stored in the FOMA terminal.
No response
ˎ
Failed to identify a recipient of iC
communication. Check if both
FeliCa marks “
” are opposed
correctly with each other or the
other device operates properly
(P.298).
ˎ
Failed to recognize the other
device for the infrared communi-
cation. Check if the infrared data
ports are pointed at each other
correctly or if the other device op-
erates properly (P.295).
No response (408)
ˎ
The communication is interrupted
because there is no response
from the site or website. Retry the
operation after a while.
No space in main memory
ˎ
Another image recorded by the
camera cannot be saved be-
cause of no memory to save it
on the FOMA terminal. Change
the image quality or image size,
or delete unnecessary images
(P.147, 154, 290).
ˎ
The remaining memory on the
FOMA terminal is insufficient.
Delete unnecessary data (P.98,
166, 167, 193, 223, 290, 326, 331).
No space to attach signature
ˎ
Failed to attach the signature
because the total number of char-
acters in the mail main body and
signature exceeds 5,000 full-width
or 10,000 half-width characters.
Decrease the number of charac-
ters in the mail main body or send
mail with no signature attached
(P.179, 196).
Not enough space in microSD
ˎ
Another image recorded by the
camera cannot be saved be-
cause of no vacant space to save
it in the microSD memory card.
Change the image quality or im-
age size, or delete unnecessary
images (P.147, 154, 290).
Not supported by this Reader/
Writer
ˎ
The recipient’s terminal does not
support the iC communication.
Continued