User's Manual Part 1

79
PushTalk
Operations during PushTalk Communication
Operation Key operation
Speak When the floor is open, you can speak only while you press and hold
.
While another member has the floor, you cannot get it even if you press
.
Add a member Press
(Add). This operation is enabled only when you originate a PushTalk
call.
Switch ON/OFF of the hands-free operation Press ( ). Every time you press the key, the ON/OFF setting is switched.
Adjust the volume of the caller’s voice Press .
Terminate a PushTalk call Press
.
Receive a voice call Press
(P.63).
If you receive a voice call, the PushTalk communication is terminated.
The operation for an incoming voice call while using PushTalk can be customized (P.87).
●
Each speech session granted by obtaining the floor is time limited. The obtained floor is released after
the time limit. The PushTalk communication is terminated if no member takes over the floor within a certain
interval.
●
When there is any change in PushTalk communication status or a member takes over the floor, the signal
tone sounds.
●
You cannot use i-mode during PushTalk communication.
●
When other functions are activated, you cannot obtain the floor. However, when you activate a function while
you have the floor, you can speak while you press and hold
.
●
When you receive a videophone call, data communication, or a PushTalk call during PushTalk
communication, a new call is saved in the Received record and the current PushTalk call is continued.