User's Manual Part 1

57
Voice/Videophone Calls
●
When a Chaku-moji is received by the recipient, “ ” appears in the sender’s terminal display and charge is
required.
●
If the recipient does not receive the Chaku-moji, “ ” appears. In this case, there is no charge. (For
example, when the recipient’s terminal does not have Chaku-moji support or if the Chaku-moji was received
in a condition other than that set using the Set Message display menu.)
●
If the recipient’s terminal has the following settings or conditions, Chaku-moji cannot be delivered to this
recipient and the call is not saved in the Received record of the recipient’s terminal. “
” or “ ” is not
displayed on the sender’s terminal and there is no charge for this transmission.
- When the recipient’s terminal is outside of the service area
- When the recipient’s terminal is powered off
- When the Public mode (Drive mode) is set
- When the To answer the Record message is set to 0 seconds, etc.
●
Even if a Chaku-moji was delivered successfully to the recipient, “ ” or “ ” may not be displayed in the
sender’s terminal display depending on the radio wave condition. In this case, charge is required.
●
If you place a videophone call with a Chaku-moji while the Auto redial(voice) is set to [ON], the Chaku-moji
is sent even when this call is redialed as a voice call.
Changing the Caller ID Setting ON/OFF for an Individual Call
<186/184>
You can choose whether to notify a recipient of your phone number (caller ID) every time
you place a call.
ˎ
The caller ID is important personal information. Carefully decide whether you want to notify a recipient of your
caller ID.
You can use the following methods to notify or not notify your caller ID.
Presetting for all calls Use the Set Notification to set [Notify]/[Not notify] (P.44).
Setting in the Phonebook Add “186/184” to the recipient’s phone number when you save it in the
Phonebook (P.91).
Setting when you place a call Set [Call with ID]/[Call without ID] at the Caller ID of the Option call display after
dialing a recipient’s phone number (P.57).
Enter “186/184” before dialing a recipient’s phone number (P.49).
To notify the caller ID
Press 186 + Phone number + .
Not to notify the caller ID
Press 184 + Phone number + .
●
When you place a call by pressing after dialing a phone number with “186/184”, the phone number is
saved in the Redial record with “186/184”.
●
You cannot set whether to notify the caller ID when you originate a PushTalk call even when you add
“186/184”.
Placing a Call by Specifying a Condition
When you place a call, you can set a call condition at the Option call display such as
selecting a call type or whether to notify a recipient of your phone number for each call.
Continued