User's Manual Part 1

50
Voice/Videophone Calls
●
See P.56 for sending the Chaku-moji and P.57 for placing a voice or videophone call by specifying the
condition.
●
For a voice call, you can also place it in the order of step 2
→
step 1. Press and enter a phone number,
and the call is dialed automatically after about five seconds.
●
You are charged for digital communication even if you send a substitute image during a call.
●
If the videophone call is not connected, the following messages appear in the display. The displayed
message may not correctly represent the status of the recipient depending on the type of the phone of the
recipient or whether the recipient has subscribed to any network service.
Message Description
Check number, then redial The phone number is no longer in use.
Busy The recipient is talking on the phone.
(
This message may appear also during packet communication on
some recipient’s terminals.)
Busy with packet transmission The recipient is using packet communication.
Outside of service area/power off The recipient is in a place where radio waves do not reach or the
phone is powered off.
Set Caller ID to ON This message appears when the call was connected without a Caller
ID (when a call is placed to Visual Net or other sites).
Please try voice call This message appears when the Call Forwarding Service is set on the
recipient’s phone and the terminal to which the call was forwarded is
not equipped with the videophone function.
(As of October 2007, this message may appear also when the Voice
Mail Service is set on the recipient’s phone.)
Connection failed This message appears when none of the above reasons apply.
Please make your call from the
i-mode web page
To view V-Live contents, visit and view an official i-mode site once,
and then place a videophone call.
Upper limit has been exceeded.
Connection failed
The upper limit set to the plan with a Limit (Type Limit or Family Wide
Limit) has been exceeded.
●
If you use the FOMA terminal to place a videophone call to emergency numbers (110, 119, and 118), it
automatically switches to voice call dialing.
●
When you place a videophone call to a terminal that is not equipped with a videophone function, or when
a recipient is outside of the service area or the phone is powered off (even if the FOMA terminal has the
videophone function), your call is not connected. When you place a videophone call to a terminal that is
not equipped with a videophone function and the Auto redial(voice) is set to [ON], the recipient’s terminal
disconnects your videophone call before it is connected, and the FOMA terminal redials the call as a voice
call. If, however, you dial a wrong number such as an ISDN synchronous 64kbps or PIAFS access points, or
ISDN videophone that is not 3G-324M (as of October 2007) compatible, the above operations may not take
place. Note also that you may be charged for the call.