User's Manual

Emergency calls

Mobile phones operate using radio signals, which cannot guarantee

connection in all conditions. You should therefore never rely solely upon any

mobile phone for essential communications (e.g. medical emergencies).

Emergency calls may not be possible in all areas, on all cellular networks,

or when certain network services and/or mobile phone features are in use.

Check with your local service provider.

Antenna

This phone contains a built-in antenna. Use of antenna devices not marketed

by Sony Ericsson specifically for this model could damage your mobile phone,

reduce performance, and produce SAR levels above the established limits

(see below).

Efficient use

Hold your mobile phone as you would any other phone. Do not cover the

top of the phone when it is in use, as this affects call quality and may cause

the phone to operate at a higher power level than needed, thus shortening

talk and standby times.

Radio frequency (RF) exposure and Specific

Absorption Rate (SAR)

Your mobile phone is a low-power radio transmitter and receiver. When it is

turned on, it emits low levels of radio frequency energy (also known as radio

waves or radio frequency fields).

Governments around the world have adopted comprehensive international

safety guidelines, developed by scientific organizations, e.g. ICNIRP

(International Commission on Non-Ionizing Radiation Protection) and IEEE

(The Institute of Electrical and Electronics Engineers Inc.), through periodic

and thorough evaluation of scientific studies. These guidelines establish

permitted levels of radio wave exposure for the general population. The

levels include a safety margin designed to assure the safety of all persons,

regardless of age and health, and to account for any variations in

measurements.

Specific Absorption Rate (SAR) is the unit of measurement for the amount of

radio frequency energy absorbed by the body when using a mobile phone.

The SAR value is determined at the highest certified power level in laboratory

conditions, but the actual SAR level of the mobile phone while it is operating

can be well below this value. This is because the mobile phone is designed

to use the minimum power required to reach the network.

K200a-SHUG-R1A-EN.book Page 31 Friday, March 2, 2007 3:56 PM

PPreflighted byreflighted byPreflighted by

( )( )( )