User's Manual

5
Getting started
Draft for Sony Ericsson Internal Use Only
To insert the SIM card and charge the
battery
1 Lift the SIM card holder in the direction
marked OPEN. Slide the SIM card into the
holder slots with the gold connectors facing
down.
2 Place the battery on the back of the phone with
the label side up and the connectors facing
each other.
3 Place the battery cover as shown in the picture
and slide it into place.
4 Open the connector cover and connect the
charger to the phone at the flash symbol. The
flash symbol on the charger plug must face
upwards.
5 It may take up to 30 minutes before the battery
icon appears on the screen.
6 Charge for 4 hours or until the battery icon
indicates a full charge. If you do not see the
battery icon after this time, press any key or
to activate the screen.
7 Remove the charger by tilting the plug
upwards.
PIN (Personal Identity Number)
You may need a PIN (Personal Identity Number) to
activate the services in your phone. Your PIN is
provided by your network operator. When you
Tamao_UG_PA3.book Page 5 Wednesday, May 19, 2004 10:26 AM