User's Manual

28
Calling
R1A Draft for US FCC approval only
Editing your voice commands
You can keep all your voice commands up to date
by re-recording them or deleting the ones you do
not use. You can also edit a voice command for a
phone number in the phonebook. Select the contact
you want to edit a voice command for } More }
Edit contact. Scroll to the relevant tab and edit your
voice command.
To re-record a voice command
1 } Settings } the General tab } Voice control }
Voice dialling } Edit names.
2 Select a voice command } More } Replace
voice.
3 Lift the phone to your ear, wait for the tone and
say the command.
Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should be
around one second long and more than one sylla-
ble.
• You spoke too late or too soon – speak immedi-
ately after the tone.
• You did not record the voice command when the
handsfree was attached – for voice control with a
handsfree kit, record when the handsfree is
attached.
• You used another intonation – use the same into-
nation as in the recorded voice command.
Diverting calls
If you cannot answer incoming calls, you can divert
them to another number, for example, your
answering service.
You can choose between the following divert
options:
• Divert always – divert all calls.
• When busy – divert calls if you are already on
the phone.
• Not reachable – divert calls if your phone is
turned off or if you are unreachable.
When the Restrict calls function is activated, some
Divert calls options are not available.
Alice_UG_R1A.book Page 28 Tuesday, May 18, 2004 11:55 AM