User's Manual

17 Handle phone calls
Draft for Sony Ericsson Internal Use Only
To make a call using voice dialling
1. Make sure the phone and the HBM-30 are on and
within range of each other. Press for at least 2
seconds to enable voice dialling.
2. After the beeps, perform voice dialling as you
normally would.
3. End the call by pressing . The HBM-30 will start
playing again. The display will show track
information, followed by elapsed time of the current
track.
Note: For more information on voice dialling,
please refer to the phone’s user documentation.
To answer a call
1. When the HBM-30 receives a call, the HBM-30
pauses the music and rings. Press to accept the
call.
Note: If the phone rings first, wait until the HBM-30
rings, then press .
2. Press to end the call. If the HBM-30 was
playing music, it will start playing again. The
display will show track information, followed by
elapsed time of the current track.
Note: If your phone supports Calling Line
Identification (CLI), the display of your HBM-30
will show the telephone number of the person calling
you.
To answer a second call
• You have to use the phone keypad to answer and
handle a second call, but you can still use the HBM-
30 for talking and listening. You cannot use the
HBM-30 buttons during a second call. Refer to the
phone's user documentation on how to handle more
than one call simultaneously.
To reject a call
• Press . The HBM-30 will continue playing.
Transferring sound from phone to HBM-30
Depending on the type of phone, you can transfer the
sound to the HBM-30 from the phone during a call.
The HBM-30 has to be on, paired with the phone,
and within range.
To transfer the sound to the HBM-30
• During a call, press . The HBM-30 beeps until
the sound has been transferred.
Enrico UG.book Page 17 Wednesday, January 22, 2003 1:51 PM