User's Manual Part 2
Connecting to other devices 151
Preliminary
PC connectivity software
Your P800 is delivered with a CD, PC Suite for P800.This
software must be installed in the PC you want to connect to. See
the chapter “Installing applications” on page 148 for more
information. You do not need to install the PC Suite for P800 if
youonlywanttoperformbeamingwiththePCoruseacordless
headset.
Connection via cable
Put your P800 in the desk stand and connect the cable to an
empty USB port on the PC. When connecting via cable, the
P800 must be set in PC connect mode or Modem mode, see
table below. The setting is made in
Control panel > Connections >
Cable
.
Serial settings
The default settings for normal use:
Connection via infrared port
When connecting via the infrared port, make sure that both
devices are placed within one metre from each other and that the
infrared ports have a free line of sight between them. The
infrared port on your P800 is located on the left-hand side, next
to the On/Off button.
Activating the infrared port
The infrared port must be activated before communication can
begin. Go to
Control panel > Connections > Infrared port
and set the
port state to
On
or
On for 10 minutes.
See the chapter “Control
panel” on page 124 for more information on infrared settings.
Connection via Bluetooth wireless
technology
You can connect your P800 to other products equipped with
Bluetooth wireless technology, for example PCs or other mobile
phones, and exchange data. Since Bluetooth wireless technology
is radio-based, transmitting and receiving devices do not have to
be in a free line of sight. This means that your P800 can stay in
your pocket while communicating. However, objects between
transmitting and receiving units might weaken the signal.
PC connect mode Modem mode
• Synchronization
• Installation of software
• Backup and restore
• P800 as a modem
• Phone Book Manager (PC
software)
Baud rate:
460800
Parity:
None
Stop bits:
1
Character length:
8
Flow control:
CTS/RTS
P800_UM.book Page 151 Wednesday, August 28, 2002 4:19 PM