User's Manual Part 2

146 Control panel
Preliminary
The WIM management dialogue consists of PIN choice list and a
WIM items list.
You can select a PIN from the PIN choice list. The WIM items
list changes content dynamically, displaying only the keys that
are protected by the selected PIN and also have an associated
certificate. Other keys that are protected by the selected PIN but
do not have an associated certificate are not shown in the WIM
item list. This is the case when WIM PIN (PIN-G) is selected.
Note This is the PIN to access the WIM. The PIN-G applies to
the whole WIM and any items that do not have a different PIN,
that is, no specific items on the WIM are linked to PIN-G.
You can change status of a PIN:
• Enable PIN: A PIN code that is enabled is requested for
authorisation of an operation. To proceed with the operation
you must enter the PIN code.
• Disable PIN: A PIN code that is disabled is not requested to
authorize an operation to proceed.
To change the PIN code:
1. Select the PIN you want to change from the choice list.
2. Select
Change PIN .
If a PIN code has been blocked, you must unblock it before it
can be used again. Select the PIN and select
Change PIN .
P800_UM.book Page 146 Wednesday, August 28, 2002 4:19 PM