User's Manual Part 1

Internet 77
Preliminary
WAP and OTA provisioning messages
WAP Provisioning and OTA messages are received by the
browser application and stored within the messaging store.
These messages are then accessed and managed by Auto setup
account in Messages. When you select a provisioning or OTA
message, dialogues are shown to aid the provisioning process.
Settings
You must set up the account for the application to work. Refer to
the Control Panel section for more information. The browser is
initially set up to work. However, you can change these settings,
if required.
The easiest way to set up Internet and WAP accounts is to ask
your Internet service provider to send you an auto setup message
containing the required setup information. The accounts will
then be set up automatically on your P800. To guarantee the
integrity of the settings, a PIN may be used.
For security reasons, some WAP pages and services, for
example on-line banking, can only be accessed from a particular
WAP account. Refer to the Control panel section for more
information.
Note Proxy settings for MMS message and for a WAP gateway
should be set in the WAP account. Other proxy settings should
be set in the Internet account.
To set up the browser
1. Select
Edit > Preferences.
2. Perform the setup according to the following:
Basic settings
– Enter the URL for the page to be shown when the browser
is started from the application picker; either a page in the
P800 or a page on the Internet.
– Select the WAP account to be used when the home page is
loaded. The accounts are set up in the control panel.
– Select if images should be loaded. If images are not
loaded, the page will be loaded faster. Non-loaded images
can be loaded manually when viewing the page.
– Select if sounds should be played when the page is
opened.
– Select if animations should be played when the page is
opened.
Security settings
– Select if you want to save signed documents.
– Select if you want to connect without giving away your
identity.
– Select if you want to connect using the WIM card.
– Select if you want to allow cookies.
Advanced settings
P800_UM.book Page 77 Wednesday, August 28, 2002 4:19 PM