User's Manual Part 1

Getting started 13
Preliminary
2. Remove the battery lid by pulling down the release catch.
3. Take out the battery.
Charging the battery
Warning! The mains (power) supply plug may look different
depending on the mains socket in your country. Do not connect
the AC-plug-in unit to any other item than your Sony Ericsson
Travel Charger or other compatible Sony Ericsson / Ericsson
chargers with the same plug.
• When the battery needs to be charged, a beep is heard, the
indicator light (on the top of your P800) blinks red and a
battery low message appears on the screen.
• The battery can be charged whenever you want without
affecting its performance. However, using your P800 while
charging lengthens the charging time.
To charge the battery
The P800 can be charged either switched on or off.
1. Make sure the battery is attached to your P800 and the lid is
closed.
2. Connect the charger to
the P800 at the flash
symbol on the P800’s
connector.The flash
symbol on the charger
plug must face upwards.
Warning! If the guidance-
pins on the charger plug are damaged, do not try to connect the
charger. If you do, you might damage the P800.
3. Connect the charger to the mains
Charging is indicated by the battery meter on the screen pulsing
continuously, and the indicator on top of the P800, showing a
steady red light (or green, if the P800 is turned on).
Note When the battery is completely discharged, or new, it may
take up to 30 minutes before the battery charging icon appears
in the screen.
4. Wait approximately 4 hours or until the battery meter on the
screen is full and the indicator on the top of the P800 shows a
steady green light.
5. Remove the charger by tilting
the plug upwards.
P800_UM.book Page 13 Wednesday, August 28, 2002 4:19 PM