User Manual

GM47/48 Technical description
BA/SEM/MS 02:0004 Rev B
13
3 System Connector Interface
3.1 Overview
The electrical connections to the module (except the antenna), are set
through the System Connector Interface.
The connector shall allow the following connections: board to board
and board to cable. The table below provides the two possible mating
connectors for the application system:
No Pin Part Number Description
1 60 9462-9101-606 Female connector (Speed Tech). Board-
Board
2 60 TBD Female connector. Board-Cable
The figure 3.1 below indicates the pin numbering scheme.
Figure 3.1 GM 47/48. View from the underside
The table on next page provides the pin assignment of the different
signals in the System Connector Interface as well as a short
description of them.
All signal directions are with respect to the module i.e. Direction 'O'
means data being sent by the module.