User Manual

3. CONTROL AND STATUS

LZT 123 7263 R1A

The previous value of S3 is used to determine the command line

termination character for entry of the command line containing the S3

setting command. However, the result code issued uses the value of S3

as set during the processing of the command line. For example, if S3

was previously set to 13 and the command line "ATS3 30" is issued, the

command line is terminated with a <CR> character (IA5 0/13), but the

result code issued uses the character with the ordinal value 30 (IA5 2/

14) in place of the <CR>.

3.5 ATS4 Response Formatting Character

This S-parameter represents the decimal IA5 value of the character

generated by the DCE as part of the header, trailer, and terminator for

result codes and information text, along with the S3 parameter (see the

description of the V parameter for usage).

If the value of S4 is changed in a command line, the result code issued

in response to that command line will use the new value of S4.

<value> Description

13 Command line termination character, Default value

0 to 127 Command line termination character

Description Command Possible Responses

Set Response

Formatting Character

ATS4=<value> •OK

•ERROR

Read the current

setting

ATS4? <value>

Show if the command

is supported

ATS4=? S4: (list of supported

<value>s)

<value> Description

10 Formatting character. Default value

0 to 127 Formatting character