User Manual

GM47/GM48 INTEGRATOR’S MANUAL
96
LZT 123 7263 R1A
Note! Call is always answered in the current fax class, regardless of whether
the incoming call is voice, data, or fax.
3.3ATS2 EscapeSequenceCharacter
Defines the character to be used as the escape sequence character when
switching from on-line data mode to on-line command mode. The
response to the command is modified to reflect the change.
Note! If the <esc> parameter is set to a value in the range of 128-255, the
escape sequence detection is disabled.
3.4 ATS3 Command Line Termination Character
This S-parameter represents the decimal IA5 value of the character
recognised by the DCE from the DTE to terminate an incoming
command line. It is also generated by the DCE as part of the header,
trailer, and terminator for result codes and information text, along with
the S4 parameter.
<rcnt> Description
0 Disable automatic answer. Default value
1-7 Answer after the specified number of rings
Description Command Possible Responses
Set escape sequence
character
ATS2=[<esc>] •OK
•ERROR
Read the current
setting
ATS2 <esc>
Show if the command
is supported
ATS2=? S2: (list of supported
<esc>s)
<esc> Description
43 Escape sequence character. Default value
0 to 255 Escape sequence character
Description Command Possible Responses
Set Command Line
Termination Character
ATS3=<value> •OK
•ERROR
Read the current
setting
ATS3? <value>
Show if the command
is supported
ATS3=? S3: (list of supported
<value>s)