User Manual

GM47/GM48 INTEGRATOR’S MANUAL
200
LZT 123 7263 R1A
13.7 ATZ Reset to Default Configuration
This command instructs the DCE to set all parameters to their default
values as specified by the user. Consider hardware configuration
switches or non-volatile parameter storage(if implemented) whenusing
this command.
Commands included on the same command line as the Z command will
be ignored.
Description Command Possible Responses
Execute ATZ •OK
•ERROR
Execute ATZ=<profile> •OK
•ERROR
Show if supported and
list available
parameter range
ATZ=? Z: (list of supported
<profile>s)
<profile > Description
0 Select the user profile to restore