User Manual

3. CONTROL AND STATUS
105
LZT 123 7263 R1A
The alarm function uses the ring type and the ring level defined with the
AT*ERIN and AT*ERIL commands.
3.17 AT+CALD Alarm Delete
This command removes an active alarm.
3.18 AT+CAPD Postpone or Dismiss an Alarm
This command controls an active (occurring) alarm by either
postponing it or dismissing it.
If more than one alarm occurs at the same time, this command dismisses
or postpones the last activated alarm.
<time> Description
string type
value
Refer to AT+CCLK command. Only minutes and hours are
used
Description Command Possible Responses
Delete an alarm AT+CALD=<n> •+CMEERROR:<err>
•OK
•ERROR
Show if the command
is supported
AT+CALD=? •+CALD:(listof
supported <n>s)
•+CMEERROR:<err>
•OK
•ERROR
<n> Description
Integer type Index identifying an active alarm
Description Command Possible Responses
Postpone or dismiss an
alarm
AT+CAPD=[<sec>] •+CMEERROR:<err>
•OK
•ERROR
Show if the command
is supported
AT+CAPD=? •+CAPD:(listof
supported <sec>s)
•+CMEERROR:<err>
•OK
•ERROR
<sec> Description
0 Dismiss the alarm
1…600 Postpone the alarm (snooze) for <sec> seconds. Not
supported
540 Postpone the alarm (snooze) for 540 seconds (9 minutes).
This is the only supported value