User's Manual

This is the Internet version of the user's guide. © Print only for private use.
Additional information 77
Do not use your product when in, or around aircraft, or
areas posted “turn off two-way radio”.
Do not use your product in an area where a
potentially explosive atmosphere exists.
Do not place your product or install wireless
equipment in the area above your cars air
bag.
Do not attempt to disassemble your
product. Only Sony Ericsson authorized
personnel should perform service.
Do not direct the infrared ray at anyone's
eye and make sure that it does not disturb any other
infrared units.
To avoid hearing impairment, accept the call before
holding your product (or portable handsfree device) to
your ear.
ANTENNA
Only use an antenna that has been specifically designed
by Sony Ericsson for your mobile phone. Use of
unauthorised or modified antennas could damage your
mobile phone and may violate regulations, causing loss
of performance and SAR levels above the recommended
limits (see below).
EFFICIENT USE
Hold your mobile phone as you would any other phone.
Do not cover the top of the phone when in use, as this
affects call quality and may cause the phone to operate
at a higher power level than needed, thus shortening talk
and standby times.
RADIO FREQUENCY (RF) EXPOSURE
AND SAR
Your mobile phone is a low-power radio transmitter
and receiver. When it is turned on, it emits low levels of
radio frequency energy (also known as radio waves or
radio frequency fields).
Governments around the world have adopted
comprehensive international safety guidelines,
developed by scientific organizations, e.g. ICNIRP
(International Commission on Non-Ionizing Radiation
Protection) and IEEE (The Institute of Electrical and
Electronics Engineers Inc.), through periodic and
thorough evaluation of scientific studies. These
guidelines establish permitted levels of radio wave
exposure for the general population. The levels include a
safety margin designed to assure the safety of all
persons, regardless of age and health, and to account for
any variations in measurements.