User's Manual

More than one call 47
1. Press , then select Transfer call to connect the
two calls. You are disconnected from both calls. This
service is operator dependent.
• Press
NO to end the ongoing call and, then press YES
to retrieve the held call.
• Press , then select Release all, to end both calls.
Receiving a third call
You cannot answer a third call without ending one of
the first two calls.
• Select Release&answer to end the current call and
answer the waiting call. The call on hold remains on
hold.
• Select Busy to reject the waiting call.
Conference calls
You can include up to four participants in a
conference call. To create a conference call,
you must have one active call and one call
on hold.
To join the two calls into a conference call
1. Press .
2. Select Join calls,
YES.
To add a new participant
1. Press
YES to put the conference group on hold.
2. Call the next person you wish to include in the
conference group.
3. Press .
4. Select Join calls,
YES.
Repeat steps 1 to 3 to include more participants.
To check the participants
1. Press .
2. Select Parties in conf,
YES.
You can have a private conversation with one
participant and put the other participants on hold.
To extract a participant
1. Press .
2. Scroll to Parties in conf,
YES.
3. Select a participant and press .
4. Scroll to Extract part. Press
YES.
To rejoin the participant
1. Press .
2. Scroll to Join calls,
YES.
T600.book Page 47 Friday, August 23, 2002 4:43 PM