VH700 Extended User guide
Contents 1.....................................................................................................3 2.....................................................................................................4 Headset overview.........................................................................5 Introduction..................................................................................6 Charging........................................................................................
1 1 2 3 5 4 6 7 8 3 This is an Internet version of this publication. © Print only for private use.
2 4 This is an Internet version of this publication. © Print only for private use.
Headset overview See illustration 1. 1 Microphone 2 Call handling key 3 Microphone 4 Volume keys 5 Charger connector 6 Clip 7 On/off key 8 Indicator light 5 This is an Internet version of this publication. © Print only for private use.
Introduction The Bluetooth™ Noise Shield Handsfree VH700 can be connected to any device with Bluetooth wireless technology that supports the headset or headset profile. This User guide focuses on use with a Sony Ericsson mobile phone. 6 This is an Internet version of this publication. © Print only for private use.
Charging Before using the headset for the first time, you need to charge it with the supplied charger for 8 hours. See illustration 2. The normal charging time is 2.5 hours. Use Sony Ericsson chargers only. 7 This is an Internet version of this publication. © Print only for private use.
Turning on and off • To turn on the headset Press and hold down until the indicator light shows a steady green or red light. If the light is red, the headset needs charging. After 3 seconds, the light turns off and the headset is on. • To turn off the headset Press and hold down until the indicator light shows a green or red light. If the light is red, the headset needs charging. After 3 seconds, the light turns off and the headset is off. 8 This is an Internet version of this publication.
Pairing the headset Pairing the headset with a phone To use the headset with a phone, you need to pair the headset with the phone. After successful pairing, the headset connects automatically to the phone as soon as the headset is turned on and within range. 1 2 3 4 5 6 7 8 To pair the headset with a phone Make sure the headset is turned off. Turn on the Bluetooth function in the phone. For instructions, see the phone User guide. Turn on Bluetooth visibility in the phone.
Multipoint With this feature, you can use the headset with two different phones at the same time. Before you use this feature, you need to enable it. 1 2 3 4 To enable the multipoint feature Make sure the headset is turned off. Press and hold down on the headset until the indicator light flashes green and red alternately. Multipoint mode: Press and hold down the plus sign on the volume key. Two orange flashes on the indicator light shows that multipoint has been enabled.
Calling • To make a call Dial the number using the phone keys. The call is automatically activated in the headset. • To end a call Press the call handling key briefly. • To answer a call A beep indicates an incoming call. Press the call handling key briefly. • To reject a call Press and hold down the call handling key until you hear a short beep (after 2 seconds). • To re-dial a number Double-click the call handling key. • To answer a second call Press the call handling key.
Battery A battery that has been infrequently used, or a new one, could have reduced capacity. You may need to recharge it a number of times. When the battery level is low, the indicator light flashes red and you hear a low beep. If you do not charge the headset, it turns off after 10 minutes. 12 This is an Internet version of this publication. © Print only for private use.
Resetting the headset Reset the headset if it behaves unexpectedly. Resetting the headset removes all information about paired devices. • • To reset the headset Press and hold down for 10 seconds. To reset the headset to factory settings Simultaneously press and hold down and the call handling key during pairing mode. 13 This is an Internet version of this publication. © Print only for private use.
Troubleshooting Redial does not work • • • Make sure the call list in the phone is not empty. Make sure the correct calling device is selected. Make sure your phone or other device supports the Bluetooth handsfree profile. The headset is automatically turned off • • The battery level is too low. You hear a beep approximately 10 minutes before the headset turns off. Charge the battery. The headset turns off if you do not pair it with the phone within 10 minutes. Unexpected behaviour • Reset the headset.
FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any change or modification not expressly approved by Sony Ericsson may void the user's authority to operate the equipment.
Industry Canada Statement This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. 16 This is an Internet version of this publication.
Declaration of Conformity for VH700 We, Sony Ericsson Mobile Communications AB of Nya Vattentornet SE-221 88 Lund, Sweden declare under our sole responsibility that our product Sony Ericsson type DDA-0002026 and in combination with our accessories, to which this declaration relates is in conformity with the appropriate standards EN 300 328:V1.7.1, EN 301 489-7:V1.3.1, EN 301 489-17:V2.1.
