User's Manual

66
Selecting system priority [F76]
If you leave the service area of a carrier from which the phone is currently receiving
signals, the phone automatically starts searching for another carrier. You can control
the order in which the phone searches for a carrier.
1 Turn to select “Set System” from the
Network menu, then push
.
The Set System menu appears.
2 Turn to set the preferences.
You can select “standard,” “home side,” “roam side,”
or “home only.” If you select “standard,” the phone
searches for the system to which you subscribe first,
then searches for an alternate system. If you select
“home side,” the phone searches for the system to which you subscribe in
all regions of coverage. If you select “roam side,” the phone searches only
for an alternate system. If you select “home only,” the phone searches for
the system to which you subscribe only in your home region.
3 Push to enter the new setting.
The standby display reappears.
Forcing the phone into analog mode [F77]
You can force the phone into analog mode for the next outgoing or incoming call.
1 Turn to select “Force Call” from the
Network menu, then push
.
The Force Call menu appears.
2 Press

1
to force the phone into analog
mode, or push
to stay in digital mode.
The following display appears. After a few seconds, the
standby display reappears. Your phone stays in analog
mode for 10 minutes, or until you terminate the call or
turn off the phone.
Note
Your phone generally stays in digital mode as long as digital service signals are received. The
phone switches to analog mode when an analog service but no digital service is available, even
if you do not perform the procedure above.
FORCE CALL
1:To Force
Analog Mode
:Quit
F77
Analog for
next 10 min
or until end
of next call
F77
SET SYSTEM
home only
:Choices
:To Set
F76
SET SYSTEM
STANDARD
:Choices
:To Set
F76
CM-M1300_50_66final 3/2/98, 11:54 AM66