User Manual

MIXING AUDIO | 203
When the Automation Settings button ( ) in the Faders control region is selected, the fader handle is displayed as with an
automation icon ( ), and you can use it to edit send volume automation on the track.
Bus sends are pre-volume (and pre-mute) by default. When bus sends are pre-volume, you can create a cue mix that is independent
of your main mix. For more information, see Creating a Cue (Headphone) Mix with the Mixing Console on page 227. To change to post-
volume (and post-mute), click the Pre/Post button to switch to Post Volume Send mode.
Changing a track’s input or output device
When the I/O control region is visible, each track displays controls you can use to set the track’s input device (for recording) and
output device.
To show or hide the I/O control region, click the I/O button in the View Controls pane. For more information, see The View Controls
pane on page 198.
To choose the recording input for the track, click the Input button and choose a port from the menu.
To route a track to a bus, click the Output button and choose a bus from the menu.
Note: The trim level is added to the automation settings so your envelope is preserved, but with a boost or cut applied. For example,
setting the trim control to -3 dB has the same effect as decreasing every envelope point by 3 dB.
Tip: To adjust the size of the Sends control region, you can drag the bottom divider to make more or fewer sends visible.