User Manual

• Ctrl+hover over fader and use wheel to move fader/slider in fine increments.
Zooming directly controls the accuracy of your editing.
Viewing playbacks and previews
CD Architect software allows you to play back your project directly from the timeline.
Using playback in CD Architect software
The transport bar allows you to play back your entire project or portions of your project based on a time selection or the current cursor
position.
Playing an entire project
1. Click the Play From Start button to begin playback at the beginning of the project.
2. Click the Stop button to stop playback.
Most of the time, you will only want to preview a small portion of the project to perfect a section. You can do this by creating a time
selection.
Playing a time selection
1. Place the mouse pointer above the ruler on the marker bar. The mouse pointer changes to
Loop bar
include a left/right arrow cursor .
2. Drag to select the time region. To increase or decrease the time selection, drag its start and
end points. The time selection is highlighted, and the loop bar appears above the ruler on
the timeline.
3. Click the Play button to begin playback.
4. Click the Loop Playback button to continually play back the events within the time
selection. Click the button again to toggle this feature off.
5. Click the Stop button to stop playback.
By looping the playback, you can repeatedly watch the same section of the project over and over
as you make changes in real time. You can define selection areas automatically, depending on what you would like to preview. For more
information, see Selecting a time range on page 46.
GETTING STARTED | 43