Operation Manual

28 © Copyright 2012 Sonuus Limited Wahoo
Owner’s Manual
P. E n on
oFF
on
o.Lo
o.hi
Pedal enable. Allows you to enable the effect by moving the
footpedal. If set to oFF then this feature is disabled.
The effect is enabled when the footpedal is pressed to the toe-
down position. The effect must be turned off using the footswitch.
On/off low (heel): the effect is enabled when the footpedal is in
the heel-down position, and is deactivated when the footpedal
returns to this position (after a time set by “pdeal effect off time”).
On/off high (toe): the effect is enabled when the footpedal is in the
toe-down position, and is deactivated when the footpedal returns
to this position (after a time set by “pedal effect off time”).
Setting P. E n to o.Lo or o.hi affects how footpedal preset selection
works—see “Foot-operated preset selection” on page 11.
P. t i 0·1 0·1–25·0
Pedal effect time off. Only available if P. E n is set to o.Lo, or o.hi.
When P. E n is set to o.Lo, or o.hi, this sets the time (in seconds)
that the footpedal must be in the “off” position before the effect is
turned off.
g.At 0 0–200
Noise gate attack—how quickly the noise gate moves the filter
cutoff frequency when the output falls to below the threshold set.
FS.t 4 (2s) oFF, 1–8
Footswitch time. Time in 500ms steps that footswitch is held to
enter and exit foot-operated preset selection mode.
Custom
sub-
parameter
Default Range Description