Full Product Manual

The Solar Mole Chaser is effective at repelling burrowing pests such as moles, gophers, and other rodents by emitting a
sonic pulse which pests find extremely piercing thereby repelling them. Pests perceive a danger zone causing them to
evacuate the area covered by the vibrating sonic sound. The vibrating sonic sound pulses at 30-second intervals and cov-
ers a surface area of over 6000 sq.ft.
The Solar Mole Chaser emits a vibration in all directions. For best results, it is recommended to use 2 units approximately
60 ft. apart in the highest risk area.
The Solar Mole Chaser works with a solar charged battery. The solar cell charges the battery during the day (even works
under cloudy conditions) and runs the unit; while night time operation is powered by the high efficiency battery .
SPECIFICATIONS:
Rated voltage: 1.2V Battery: 1 X 1.2V 600mA Ni-Cd rechargeable battery
Frequency: 400Hz-1000Hz Range: >6000 sq. ft
NOTES:
Remove unit in extreme weather conditions like hail, ice, snow, or flooding. Although unit is weatherproof, avoid 1.
direct exposure to sprinkling systems.
For Hard Earth Locations, It is recommended to dig small opening to place solar mole chaser into the earth.2.
Do not use a hammer or mallet or excessive force to insert the solar mole chaser – this may damage the unit. 3.
Clean the solar cell cover periodically with a damp cloth to ensure maximum sun exposure.4.
WARNING:
Always wear ANSI approved safety goggles when setting up this product. 1.
Never allow children to play with this product.2.
Do not handle live moles, gophers and other rodents as they can be dangerous and may carry diseases. 3.
INSTALLATION PROCEDURES (SEE DIAGRAM BELOW):
Press the ON/OFF button underneath the head. You can then hear sound, which indicates the product is under 1.
proper working condition. It is recommended to charge the product for at least one full sunny day before its first
operation.
Insert spike into lawn paying attention not to damage unit. The spike should be firmly planted while leaving the 2.
base of the head at approximately one inch from ground level.
The built-in battery might need to be replaced once every year. Release the 6 screws besides the ON/OFF button, 3.
remove the cover, and then replace the old battery with a 1.2V AA size
rechargeable battery. Please put the cover
back on and tighten the screws after battery is replaced.
[e-mail]
2
1-800-348-5004