User's Manual

Rev.1.01
2022. 03.
35 / 96
Doc # : BN-SM-EOP-01
Do not dispose of the product carelessly.
- Battery recycling must meet local requirements.
- Waste must be disposed of in compliance with local regulations.
4.6 Maintenance & Protection
1. This product usage and storage conditions shall comply with the environmental
conditions of Appendix A in this manual.
2. The product power supply shall be in accordance with Appendix A in this manual.
3. If the product is not used for a long time, charge it at least 2 times a week for at
least 1 hour.
4. Do not tamper with the probe cover to clean or disassemble the components inside
the probe.
5. Clean the cover with alcohol-cotton after turning off.
6. This product should not be started up and shut down too often. If you need to
restart, wait at least 1 minute for booting after shutdown.
7. If any problem is happened, stop using the device and contact Bionet’s Customer
Service department.
8. Since the probe is vulnerable to external impact, collision or falling is prohibited.
9. If you want to pause during scanning, use the “Freeze” function. In freeze status, the
device can be kept on standby for a long time.
10. Only use the appropriate ultrasound gels for medical standard.
11. The probe is waterproof but, do not immerse the probe in conductive liquid to
minimize corruption.
12. Check for cracks regularly to avoid liquid immersion and damage of internal
components.
13. Refer to chapter 4.2 about how to clean and disinfect.
14. To maintain the performance and safety of the system, regular electrical and
mechanical safety inspections of the system must be performed by professional
technicians in less than six months.
15. Excessive shocks, such as a fall, may seriously damage the product. In this case,
contact Bionet’s Customer Service Department for maintenance and repair.