User's Manual

Rev.1.01
2022. 03.
32 / 96
Doc # : BN-SM-EOP-01
Chapter 4. Maintenance
4.1 Charging Probe
4.1.1 USB Charging
When the battery is low, the probe needs to be charged. Remove the rubber cover
from the tip of the probe and then plug one end of the USB cable into the USB charging
port in the probe as shown in Figure 4-1. The battery level indicator blinks while
charging.
The battery is fully charged when both the battery level indicator and the wireless link
indicator are not blinking. When charging is complete, remove the USB cable and then
put the rubber cover into the USB charging port to avoid liquid and device damage.
[Figure 4-1] Probe Charging via USB Cable
4.1.2 Wireless Charging
- Plug one endo of the USB cable into the wireless charging pad. Place the probe on
the wireless charging pad. The probe lights up and starts charging after 1~2 seconds.
- Ensure the probe is centered on the wireless charging pad. For efficient charging,
place the probe, place the probe within 7㎜ left and right from the center of the
wireless charging pad. If it is significantly out of the range, it may be unstable or
may not charge.