User's Manual

Rev.1.01
2022. 03.
17 / 96
Doc # : BN-SM-EOP-01
Warning
If there are any of the above problems, there may be a problem with the product,
so please contact Bionet’s Customer Service Department.
- The Indicators of Wireless Signal Status and Battery Level in the probe are not
invisible till the probe is turned on.
- Press the power button for a second and turn on. After turning on, you can
check the status of battery level. There are 4-Step battery level. (Refer to chapter
4 for how to charge)
- The wireless signal indicator flashes after a few seconds after turning on the
probe. This lets you know that the probe is ready to connect with your tablet PC
or mobile phone.
- The probe can be turned off by holding the power button down for about 5
seconds. When the probe is turned off, all indicators (wireless signal status and
battery level) are turned off, too.
2.4 Wireless Connection
If the probe is ready for wireless connection as described previously, turn on Wi-Fi (if not
turned on) in the settings of your tablet PC or mobile phone, and find the SSID of the
probe.
The SSID is something like "SX-xxxxxxx000 (X=uppercase, x=lowercase, 0=number)".
Before connecting, check that the last 7 digits of the 11-digit ID written on the back of
the probe match the last 7 digits of the SSID.
When connecting for the first time, you need to enter a password, which is a total of 11
digit ID written on the back of the probe.
After Wi-Fi is connected, launch the SonoMe app. When the app confirms the connection
with the probe, the wireless signal indicator on the probe stops blinking. When the
connection is complete, start to Scan.