User's Manual

Rev.1.01
2022. 03.
38 / 57
Doc # : BN-SF-EOP-01
- Check the probe for cracks, broken parts, liquid leaks, sharp edges, etc. If there is any
damage, stop using the probe immediately and contact Customer Service
Department.
Warnings:
- This product is intended for use by, or by the order of, and under the supervision of,
a licensed physician who is qualified for direct use of medical devices.
- This system may only be maintained by persons approved or trained by Bionet.
- Always use application-specific probes in order to obtain the best quality images.
- Never use the product in the presence of flammable or anesthetic gas. Doing so may
cause an explosion.
- Do not use the system simultaneously with other equipment such as electric knives,
defibrillators, and other high-frequency therapy equipment. Otherwise, there is a risk
of electric shock
- Keep the system dry and do not transport to sites with rapid environment changes
to avoid short circuits caused by condensation or water droplets.
- The product must be connected to a power supply with a protective earth to prevent
electric shock.
- After reading the manual thoroughly, set and control the acoustic power level.
6.1.2 Mechanical Safety
Warnings:
- Be careful when holding the device, for it is handhold, it may fall.
- Do not use shell cracking equipment.
6.1.3 Probe Safety Precautions
- Please only use the ultrasound gels sold legally. Always follow the instructions in the
User Manual. To prevent contamination, use and take care of ultrasound gel properly.
Warnings:
- Disconnect the probe from the system after freezing the image or turning the system
down. Otherwise, the system or probe may be damaged.