User's Manual

Rev.1.01
2022. 03.
31 / 57
Doc # : BN-SF-EOP-01
3
Displayed on the screen with noise
and interference like snow
Check whether other equipment
started which cause electromagnetic
interference. If so, shut down the
device or get far from the device.
4
The brightness of image is not
enough
Adjust the brightness and gain
5
Charging is NOT work
Check whether the USB interface,
circuit and electrical outlet are
damaged or not.
4.5 Disposal
Warning
Do not dispose of the product carelessly.
- Battery recycling must meet local requirements.
- Waste must be disposed of in compliance with local regulations.
4.6 Maintenance & Protection
1. This product usage and storage conditions shall comply with the environmental
conditions of Appendix A in this manual.
2. The product power supply shall be in accordance with Appendix A in this manual.
3. If the product is not used for a long time, charge it at least 2 times a week for at
least 1 hour.
4. Do not tamper with the probe cover to clean or disassemble the components inside
the probe.
5. Clean the cover with alcohol-cotton after turning off.
6. This product should not be started up and shut down too often. If you need to
restart, wait at least 1 minute for booting after shutdown.
7. If any problem is happened, stop using the device and contact Bionet’s Customer