Manual
Table Of Contents
- Introduction
- The Oxford DeClicker
- The Oxford DeBuzzer
- The Oxford DeNoiser
- Preset Manager Toolbar
- Supported Platforms
- System Requirements
- Copyright and Acknowledgements
3.6 DescriptionofControls 3 THE OXFORD DEBUZZER
SHARP/Q
Adjusts the width or sharpness of the notches. When too sharp, the filters tend to
ring. When too wide, the filters take out too much of the audio around the
harmonics. So adjusting this is a matter of finding a suitable compromise.
ATTENUATION
Set this to the minimum attenuation that will make the hum or buzz inaudible.
3.6.4 InputandOutputPanels
TRIM
Trim the input and output gain of the plug-in.
Meters
The input and output meters indicate 1dB per segment for the top 18dB of
dynamics range, and 2dB per segment thereafter.
REDUCTION
Indicates the amount of buzz removal.
LISTEN AUDIO
Selects auditioning of the cleaned audio signal.
LISTEN DIFF
Selects auditioning of what is being removed from the audio signal.
MASTER ENABLE
With MasterEnable selected, all processing is active. If not selected, all repairs are
disabled, although all the detection circuits remain active.
www.sonnox.com 30 Gotocontents