Manual
Table Of Contents
- Introduction
- The Oxford DeClicker
- The Oxford DeBuzzer
- The Oxford DeNoiser
- Preset Manager Toolbar
- Supported Platforms
- System Requirements
- Copyright and Acknowledgements
3.6 DescriptionofControls 3 THE OXFORD DEBUZZER
3.6.3 RemovalPanel
COMB
Sets the removal filters to be a comb filter. Comb is best for Auto mode, and for
when there are many harmonics in a buzz.
PARAM EQ
Sets the removal filters to be a narrow notching parametric EQ. You may prefer the
sound of these filters when there are few harmonics. Also, it is probably best to
select ParamEQ to remove an HF whine; if the user selects the HF frequency band
while in Comb mode a small red indicator flashes on this button as a reminder.
+EVEN
When using the ParamEQ option, by default even harmonics are not notched out
because frequently they are not present. Enabling this control will notch out even
harmonics.
RANGE
This sets the frequency above which there are no notches. This needs to be as low
as possible to avoid loss of MF and HF information, but high enough to take out all
the harmonics of a buzz. Range cannot be set lower than 10% above the
fundamental.
www.sonnox.com 29 Gotocontents