Manual
Table Of Contents
- Introduction
- The Oxford DeClicker
- The Oxford DeBuzzer
- The Oxford DeNoiser
- Preset Manager Toolbar
- Supported Platforms
- System Requirements
- Copyright and Acknowledgements
2.6 DescriptionofControls 2 THE OXFORD DECLICKER
2.6.2 De-Pop, De-ClickandDe-CracklePanels
THRESHOLD
This control is used to adjust a threshold level within the Excitation Profile to capture
an event. If a peak on the Excitation Profile is below the threshold, it will not be
registered as an event to be repaired. If a peak breaches the threshold line, then it is
registered as a detected event and can be repaired.
SENSITIVITY
This control determines whether detected events are discarded, starting with the
smallest. A low Sensitivity means only the largest of the detected events go
forwards to the repair section.
ENABLE
With the section disabled, the detectors are still monitoring the audio and any
detected events are shown on the Events Graph as red bubbles. Setting the section
IN will present the detected events to the repair processing section.
DETECT Meter
The Detect meter display combines two indications. The main rising column
indicates the sum of the energy of events that have been detected. With the
“Enable” button de- selected (ie. the repair circuit disabled), this column is coloured
orange/red. With the repair circuit active the column is coloured blue. The bottom
segment of the meter is an indication of each individual detected event.
www.sonnox.com 11 Gotocontents