Manual

Table Of Contents
!
58
Output Section
MONITOR — Indicates the plug-in’s audio output; either INPUT (ie. the
plug-in is bypassed) or CODEC. You can switch between input and codec
output by clicking on the LEDs. A special case for the mp3-HD codec, whereby
the MONITOR signal is synthesized, is denoted by an INPUT 16 indication.
DISPLAY TYPE — Toggles between a Lissajous phase display and the FFT
display.
DISPLAY LOG/LIN — Toggles between logarithmic and linear scale FFT
displays.
RECORD — Writes the active codecs pre-selected for record-arm to disk.
CODEC — When selected, will route the encoded signal to the output.
DIFF When selected will route the difference signal to the output. The difference signal is
the output encoded signal subtracted from the unprocessed input signal.
MASTER IN — With the IN button selected, all processing is active. If not selected, the
outputs are disabled. However, much of the processing remains active, for example, the FFT
display and the overload detection. The MASTER IN control is automatable.
The five MON buttons and the MASTER IN, CODEC and DIFF buttons all provide
smoothly interpolated and glitch-free audio switching. It is advisable to use these for
auditioning, rather than using the host application’s bypass function (which is commonly not
interpolated).
!