Manual
Table Of Contents
- Introduction
- Supported Codecs and Formats
- The Sonnox Fraunhofer Pro-Codec
- Additional Information on Workflows
- Lossless Codecs (mp3-HD and HD-AAC)
- Description of Controls
- Presets and Project/Session Data Handling
- Preset Manager Toolbar
- Pro-Codec Signal and Control Flow Diagram
- Specifications
- Copyright and Acknowledgements
- Manual Revision History
- Platform Specific Supplement
!
55
TOTAL DELAY — This window shows the total delay through the plug-in; click to toggle
between samples or milliseconds. The figure given is the maximum of each individual codec
delay. This field is updated in the GUI immediately a new codec or other setting is selected.
Depending on the host behaviour, the new value may not be available for delay compensation
until the plug-in is removed and re-instantiated.
Online Encode Tab
CODEC LIST — Displays a list of codecs chosen
for auditioning. The codec type, bit-rate and codec
mode are displayed at all times. Any codec pre-loaded
in the list can be auditioned without glitches. You can
click and drag to re-position codecs in the list
(Windows only), or remove codecs by clicking on the
little blue ‘x’ tab at the right hand side of each codec window.
MON (x5) — These select the active codec for routing to the output section. All monitor
paths are delay compensated for glitch-free switching.
ARM (x5) — Prepares an activated codec in the codec list for writing to disk.