Manual

19
LF and HF Filter Sections
The LF and HF buttons switch the relevant filter in/out. The numeric button above
determines the slope of each filter from 6dB – 36dB/octave in 6dB/octave steps. The rotary
control determines the filter turnover frequency.
LF, HF, LMF, LMF Sections
The FREQ control sets the centre frequencies for bandpass or turnover frequencies for shelf
curves. The Q control determines the bandwidth of EQ curves, and sets the amount of
overshoot function for shelving sections.
Two buttons to the left and right of the LF and HF gain controls select the shelving function
for these sections.
The +/- rotary controls set boost or cut gains for each section. If your host supports scroll-
wheel operation to the knob controls, then each increment or decrement of the scroll wheel
will increase/decrease the gain value by exactly 0.5dB, thus allowing for an accurate
incremental step.
The IN buttons enable individual sections of the EQ to be switched in/out.
A and B Buttons
Two complete EQ / filter settings can exist simultaneously. The A and B buttons allow you to
toggle between them for comparison purposes.
Main Gain Control
This sets the attenuation level of the complete EQ section to avoid clipping signals when in
boost.
EQ Type Selection
The +/- buttons increment through the available EQ types, as shown in the character display
above.