Manual
Table Of Contents
- Introduction
- Operation
- ‘Front Panel’ Controls
- Dynamics Control
- Compressor
- Limiter
- Expander
- Gate
- Sidechain EQ
- Warmth
- Max Trim Control
- Dither Control
- Buss Compressor (Pro Tools TDM only)
- Description of Controls
- Preset Manager Toolbar
- Specifications
- Copyright and Acknowledgements
- Manual Revision History
- Platform Specific Supplement
4
2. Operation
2.1 ‘Front Panel’ Controls
The separate dynamics functions have their own control sets that are available at any time by
operating the appropriate ACCESS button for that section. Operating the IN button for any
section will force the controls for that section to the foreground of the GUI for convenience.
The IN buttons can be used to toggle the contributions from each section on and off, for
comparison purposes. Button illumination displays indicate which sections are in and which
control set is being accessed. Control setting parameters are permanently available during
operation, and specific values can be typed into the parameter windows at any time. Where
functions apply to the overall dynamics rather than single sections, their parameters and
buttons are visible permanently.
Overall input/output levels and section contribution meters are permanently visible for
reference. The four section gain contribution meters (top centre of the display), GATE, EXP,
COMP, LIMIT display the gain reduction contribution of each section separately, the
maximum of which at any time will determine the instantaneous gain reduction of the
complete dynamics plug-in.